Digital display light incubator 1. The shell of the incubator should be reliably grounded. 2. The incubator should be placed in a cool, dry, well-ventilated place away from heat sources and sunlight. Place it steadily to prevent vibration and noise. 3. In order to ensure the effective heat dissipation of the condenser, the distance between the condenser and the wall should be greater than 100mm, the side of the box should have a gap of 50mm, and the top of the box should have at least 300mm of space. 4. During transportation, repair and maintenance of the incubator, avoid collision, shaking and vibration, and the maximum inclination is less than 45 degrees. 5. The instrument suddenly does not work, please check whether the fuse tube (behind the box) is burnt out, and check the power supply. 6. When cooling the incubator, it is not advisable to make the difference between the temperature in the chamber and the ambient temperature greater than 25 degrees. 7. Illumination time can be programmed and controlled by the "programmable time controller. Please refer to the instruction manual of the programmable time controller for programming method.
Digital display shaking incubator 1. Accurate use and attention to the maintenance of the instrument, so that it is in a good working state, which can extend the service life of the instrument. 2. During the continuous working period of the instrument, periodic inspections should be done every three months; check the fuses, control components and fastening screws, and whether there are water drops, dirt, etc. falling on the motor and control components. 3. The bearings of the transmission part have been filled with a proper amount of grease (No. 1 calcium-naki) before leaving the factory. The instrument should be filled with grease every six months during the continuous operation of the instrument, and the filling amount accounts for about 1 of the bearing space. / 3. 4. The instrument is used regularly, and natural wear is normal. After the instrument is used for one year, if abnormal noise is found in the motor and compressor; the bearing of the transmission part is worn, the belt is loose or cracked, and the failure of the electronic control component is found by the manufacturer. 5. The compressor should avoid continuous starting.
The company's main business and production scope include: testing instruments, laboratory equipment, cleaning equipment, environmental protection equipment and undertaking the design and customization of non-standard products and providing related technical services. First-class technology, first-class service.A wooden box is a container made of wood for storage or as a shipping container.
Construction may include several types of wood; lumber (timber), plywood, engineered woods, etc. For some purposes, decorative woods are used.
Boxes and crates are not the same. If the sheathing of the container (plywood, lumber, etc.) can be removed, and a framed structure will remain standing, the container would likely be termed a crate. If removal of the sheathing resulted in there being no way of fastening the lumber around the edges of the container, the container would likely be termed a wooden box.
The strength of a wooden box is rated based on the weight it can carry before the cap (top, ends, and sides) is installed. "Skids" or thick bottom runners, are sometimes specified to allow forklift trucks access for lifting.
Performance is strongly influenced by the specific design, type of wood, type of fasteners (nails, etc.), workmanship, etc.
Some boxes have handles, hand holes, or hand holds.
Wood Box,Solid Wood Box,Wood Gift Box,Custom Wooden Box,Unfinished Wood Box,Wood Storage Box
Jinan Tri-Tiger Technology Development Co., Ltd , https://www.tritigerwooden.com