Blanketing

During the printing, it was found that the strokes of individual words were broken into two parts. There is no problem to view the printing plate. Look at the blanket with a needle-thin mini-thickness mark with a length of about 0.5 cm, which happens to divide the stroke of the word. I wanted to loosen the blanket and move it to the mouth or the tip. Considering that I could push the mark to the blank space of the word, it will inevitably affect other words when I change the version. If the pad blanket is very troublesome. In this regard, I think of a way that has been tested very effectively, and do not use padding blankets. The method is very simple, that is, using a steel needle into the mini-marks rolled on the blanket, gently pick, then use a finger or a piece of paper, etc. a little bit of gasoline, drip along the needle into the blanket, and then pull the needle Out. When the rubber blanket swelled with gasoline, the mark disappeared. When it is reprinted, the words that lack pen and ink are complete. This method is only applicable to extremely small rolling marks where the blanket is not cracked.