I believe that your friends should always encounter the lack of ink in the printer. The cost of re-changing an ink cartridge is too high, and it won't be able to draw it. If you add ink and do not operate it, it is indeed a very headache. The landlord also has an HP printer. Because it is often used, the ink cartridges are updated very quickly, but I have a set of experience for ink cartridges.
Because the landlord's HP printer is a direct supply from the factory, the print quality has been good, the price is also very reasonable, the usual office supplies of the landlord are purchased here, the platform of the Chenguang Group is still relatively People are relieved. And the landlord also bought a lot of spare printer ink at the same time, each time you have no ink, you manually add it, the cost is very low, the following landlord will come to share with you the specific steps of HP printer plus ink!
1. Pad a paper towel or other hygroscopic material on the table to absorb the spilled ink.
2. Gently remove the label paper from the ink cartridge (do not tear it, add it to the ink and stick it back) to expose the ink filling hole.
3. Place the ink cartridge on the spread paper towel (the nozzle is down).
4. The five small holes arranged under the label are air guiding holes and ink filling holes. The holes are correctly pointed to the light (or inserted with a toothpick) to correctly distinguish the positions of the three colors to be inked (black is generally added to the middle hole). Remove the spring bottle with the ink of each color, remove the sealing cap (carefully discharge the air in the spring bottle), insert the needle from the ink filling hole until the end is finished, then pull out 2-3MM, and slowly squeeze the ink bottle with your finger. While the needle is being injected, the needle is slowly pumped out. The black ink cartridge is expected to be added to 3-5ML. The color ink cartridge is expected to stop when it is added to the 3ML volume; it should not be larger than the capacity absorbed by the ink cartridge, otherwise it will cause ink leakage!
5. Place the ink cartridge (inking hole up) on the top of the table and shake the cartridge two to three times from top to bottom. So that the sponge in the cartridge absorbs the ink sufficiently.
6. Gently wipe the nozzle of the ink cartridge with a paper towel, and gently press the nozzle with a paper towel. If the paper towel has ink, it can be installed and printed, and the label paper should be pasted back. If you do not use ink to hold the nozzle with a paper towel, force it a few times in the air (the nozzle is facing down) to remove the air, then wipe the ink cartridge out of the ink and wipe it clean. You can print it on the machine. If you are not in a hurry, put the ink cartridge back into the printer. Set it for about 10 minutes, then perform 1 to 2 "head cleaning", then test print or nozzle test.
The above is the step of the printer to add ink, it is very simple! However, it is also necessary to pay special attention to the fact that the color ink cartridge should be carefully handled when self-priming, so as to prevent the ink from overflowing into the other holes and causing color mixing. So you can use a paper towel to remove excess spilled water and then go to the machine!
NINGBO BABY FIRST BABY PRODUCTS CO.,LTD. , https://www.maxinfcarseat.com