In the decoration of the living room, the lamps are mainly used for lighting in the living room. According to the needs, there are many lamps for the living room to be installed. Usually there are lighting strips for the living room, floor lamps and table lamps. The living room light strip design can make the room look more beautiful. It is a kind of decoration method that many decoration owners will choose. Do you know how to install the living room light strip ? This article describes these things for you.
First, the introduction of LED lights
When the LED light strip is used for living room decoration, the installation is very simple because it does not have to withstand wind and rain. Take LED light strips produced by Guanghong Electronics as an example. Each LED light strip has a self-adhesive 3M double-sided adhesive tape on the back. When installing, you can directly tear off the sticker on the surface of 3M double-sided adhesive tape, and then fix the light strip in need. Place it by hand and press it flat with your hand. As for some places that need a corner or a long length, it is very simple. The LED light strip is a circuit structure consisting of three LEDs in a series-parallel manner. Each of the three LEDs can be cut and used separately.
Second, the controller connection method
The LED marquee belt and the RGB full-color strip need to use the controller to achieve the changing effect, and the control distance of each controller is different. In general, the simple controller has a control distance of 10 to 15 meters, and the remote controller The control distance is 15 to 20 meters and the length can be controlled to 30 meters. If the LED strip has a long connection distance and the controller cannot control that long strip, then a power amplifier is needed for tapping.
Third, the specific steps
Before installation, insert the lamp with the pin into the lamp strip, pick up the lamp with the power cord and plug it into the lamp strip with the pin inserted. Plug the power cord plug into the socket and test whether the lamp strip is on, if it is not bright. Then either plug it in or insert it into the hole. If you plug it in, just pull the power cord out of the flip direction and insert it. After the test is bright, the pins and the lamp and the power cord of the lamp are evaluated with a black tape. Cut the lamp with the power cord to the side of the plug, and use the stripper to open the two wires inside to the reserved zero-fire line on the reserved position of the lamp to be installed.
The above is about the installation of the living room light belt, I hope to help everyone! Qi installed network, China's well-known large-scale decoration platform, decoration leading brand. If you want to make a new design, you are advised to apply for the free design service of the net, and help you plan a reasonable space layout and beautiful design through the professional designer's on-site measurement room.
>> Click here for professional designer free room design
Restaurant Set,Set Menu Restaurants,Table Chair Set For Restaurant,Commercial Kitchen Setup
Foshan Haoyu Furniture Factory , https://www.hyluxuryfurniture.com