[ Chinese wardrobe net ] The most basic need to drill, hinge hole, bench drill, if you make aluminum, you also need cutting machine, 45 ° angle cutter, air compressor, these are temporarily enough, after Need to develop and then slowly add it.
What is the difference between a two-row drill and a multi-row drill?
If you want to make a wardrobe , you really have to buy three rows, if you buy a double row. It is very troublesome to do. Hit the hole of 10MM to put it down. The hole that hits 8MM has to be turned up again, and the efficiency is not generally low. And you should pay attention to buying three rows. The track below is to be railed. Do not screw-type. The control panel above should be manual. Don't use that kind of microcomputer. It is especially troublesome to break. The three-row turn now has a minimum of 3-4W. If you buy a double row. It can be cheaper. But you will regret it sooner or later. Ha ha. Buying equipment is still good in one step.
How to grasp the height of the hinge hinge installation, is there any special standard requirements?
There are basically three different ways to install
1, full cover
The doors completely cover the side panels of the cabinet with a gap between them so that the doors can be opened safely. Straight arm 0 mm
2, half cover
In this case, the two doors share a side panel. There is a minimum total gap required between them. The door covering distance is correspondingly reduced, and a hinge bent by a hinge arm is required. Middle music (9.5 mm)
3, built-in
In this case, the door is located inside the cabinet, next to the side panel of the cabinet. It also requires a gap so that the door can be opened safely. A hinge with a very curved hinge is required.
Daqu (16 mm)
Serving Platter,Dinner Platter,Oval Platter,Kitchen Platters
NINGBO HAIFU PLASTIC APPLIANCE CO.,LTD , https://www.hifel.com